Tall Dog Electronics
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Introduction
Details
Guide Steps
Review
Quiz
Stack the mask material in the following order, from the bottom up:
One sheet of interface material.
One sheet of cotton fabric, with the front side facing up.
The orientation of the fabric only matters if you're using a printed fabric that has a distinct front and back. In this stack, the front sides should be facing each other. I'm using plain fabric and both sides are the same.
The second sheet of cotton fabric, with the front side facing down.
The second sheet of interface material.
The cut pattern, facing up.
Insert pins through all the layers of the stack. Make sure there are no wrinkles or bunches, and that the pattern does not extend beyond any of the edges.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.