Position the prepared Assembly Template above the Control Board as shown.
Gently slide the Assembly Template down over all the loose components and the Assembly Spacer.
The Assembly Template may have to be gently wiggled in order to ensure that it is fully seated on all of the components underneath it. Both of the metal standoffs should sit flush against the top surface of the Control Board below.
Verify that all components are seated correctly and are sticking out through the top surface of the Assembly Template as shown.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.