Place all of the remaining components onto the Control Board:
Place the twelve jack components J1-12.
Place the two button components S2 and S3.
Place the six potentiometer components P1-2 and P4-7.
Place the dual-gang potentiometer component P3.
The leads on component P3 must be bent in order for it to fit properly next to J6. Start by using pliers to straighten all of the leads, then re-bend all of the leads down as close to the body of the component as possible. Then place the component.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.