Step Type:

Drag to rearrange

Remove the three M2.5 × 6 mm pan head machine screws from the Main Board side of the assembly and put them aside for the next iteration.

Gently lift the Main Board away from the Assembly Template and the Assembly Spacer. They should both slide off easily without applying much force.

Inspect the Main Board assembly and verify that both of the following statements are true:

There are no gaps between the plastic bases of components J1-12 and the top surface of the Main Board.

The shafts of components S1-4 rise perpendicularly (at a 90º angle) compared to the top surface of the Main Board.

This completes the process.

Leave the three standoffs attached to the Assembly Template and skip Step 1 on the next iteration of this process.

Your contributions are licensed under the open source Creative Commons license.