Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Remove the Assembly Template and Spacer
-[* green] Remove the three ***M2.5 × 6 mm pan head machine screws*** from the Main Board side of the standoffs and put them aside for the next iteration.
-[* black] Gently lift the Main Board away from the Assembly Template and the Assembly Spacer. They should both slide off easily without much force.
+[* green] Remove the three ***M2.5 × 6 mm pan head machine screws*** from the Main Board side of the assembly and put them aside for the next iteration.
+[* black] Gently lift the Main Board away from the Assembly Template and the Assembly Spacer. They should both slide off easily without applying much force.
[* black] Inspect the Main Board assembly and verify that both of the following statements are ***true***:
- [* black] There are ***no gaps*** between the plastic bases of components ***J1-12*** and the top surface of the Main Board.
- [* black] The shafts of components ***S1-4*** rise ***perpendicularly*** (at a 90º angle) compared to the top surface of the Main Board.
+ [* light_blue] There are ***no gaps*** between the plastic bases of components ***J1-12*** and the top surface of the Main Board.
+ [* blue] The shafts of components ***S1-4*** rise ***perpendicularly*** (at a 90º angle) compared to the top surface of the Main Board.
[* black] This completes the process.
-[* icon_note] Leave the three standoffs attached to the Assembly Template. On your next iteration, you can skip Step 1.
+[* icon_note] Leave the three standoffs attached to the Assembly Template. On the next iteration, skip Step 1.

Image 3

Old Version

New Version