Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Place the Assembly Template
[* black] Position the prepared Assembly Template above the Main Board as shown.
[* black] Gently slide the Assembly Template down over all the loose components and the Assembly Spacer.
- [* icon_note] You may have to gently wiggle the Assembly Template to ensure that it is ***fully seated*** on all of the components underneath it. Each of the metal standoffs should sit ***flush*** against the top surface of the Main Board PCB below.
-[* black] Verify that all components are ***seated correctly*** and are ***sticking out*** through the top surface of the Assembly Template.
+ [* icon_note] You may have to gently wiggle the Assembly Template to ensure that it is ***fully seated*** on all of the components underneath it. Each of the metal standoffs should sit ***flush*** against the top surface of the Main Board below.
+[* black] Verify that all components are ***seated correctly*** and are ***sticking out*** through the top surface of the Assembly Template as shown.