Changes to Step #4
Edit by Daniel Gilbert —
Edit approved by Daniel Gilbert
- Before
- After
- Unchanged
Step Lines
[title] Place the Assembly Template | |
[* black] Position the prepared Assembly Template above the Main Board as shown. | |
[* black] Gently slide the Assembly Template down over all the loose components and the Assembly Spacer. | |
[* icon_note] You may have to gently wiggle the Assembly Template to ensure that it is ***fully seated*** on all of the components underneath it. Each of the metal standoffs should ***sit flush*** against the top surface of the Main Board PCB below. | |
- | [* black] Verify that all components are ***seated correctly and sticking out*** through the top surface of the Assembly Template. |
+ | [* black] Verify that all components are ***seated correctly*** and are ***sticking out*** through the top surface of the Assembly Template. |