Changes to Step #2
Edit by Daniel Gilbert —
Edit approved by Daniel Gilbert
- Before
- After
- Unchanged
Step Lines
- | [title] Populate the |
---|---|
+ | [title] Populate the Main Board components |
[* black] Identify the Main Board assembly PCB. It has part number TD-OCSE-D2-MB printed on its bottom side. | |
[* icon_caution] The Main Board should have all surface mount soldering already completed before continuing. | |
[* icon_note] For ease of access to the pads, it is recommended to solder component H5 before continuing. | |
[* icon_caution] Do not solder any components until being instructed to later. | |
[* red] Populate two components S1 and S4. | |
[* orange] Populate two components S2 and S3. | |
[* yellow] Populate twelve components J1-12. | |
[* icon_note] Note that four pairs of these components (J1/2, J4/5, J7/8, and J10/11) share a common hole for their grounding pins. |