Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Populate the Main Board components
-[* black] Identify the Main Board assembly PCB. It has part number TD-OCSE-D2-MB printed on its bottom side.
+[* black] Identify the Main Board assembly PCB. It has part number ***TD-OCSE-D2-MB*** printed on its bottom side.
[* icon_caution] The Main Board should have all surface mount soldering already completed before continuing.
- [* icon_note] For ease of access to the pads, it is recommended to solder component H5 before continuing.
-[* icon_caution] Do not solder any components yet.
-[* red] Populate two components S1 and S4.
-[* orange] Populate two components S2 and S3.
-[* yellow] Populate twelve components J1-12.
- [* icon_note] Note that four pairs of these components (J1/2, J4/5, J7/8, and J10/11) share a common hole for their grounding pins.
+ [* icon_note] For ease of access to the pads, it is recommended to solder component ***H5*** before continuing.
+[* icon_caution] Do not solder any of the following components yet.
+[* red] Place components ***S1*** and ***S4***.
+[* orange] Place components ***S2*** and ***S3***.
+[* yellow] Place components ***J1-12***.
+ [* icon_note] Note that four pairs of these components each share a common hole for their grounding pins.

Image 2

Old Version

New Version