Changes to Step #1
Edit by Daniel Gilbert —
Edit approved by Daniel Gilbert
- Before
- After
- Unchanged
Step Lines
[title] Prepare the Assembly Template | |
[* icon_note] You only need to do this step once. The standoffs can remain attached to the template permanently. | |
[* black] Identify the green Assembly Template PCB. It has the part number ***TD-OCSE-D-AT*** printed on it. | |
- | [* red] Note the orientation of the board. The standoffs will be installed on the side that |
+ | [* red] Note the orientation of the board. The standoffs will be installed on the side that has ***THIS SIDE FACES DOWN*** printed on it. |
[* orange] Locate three ***M2.5 × 10 mm female standoffs***. | |
[* green] Secure each standoff using one ***M2.5 × 6 mm pan head machine screw*** in each of the three locations shown. | |
[* black] Flip over the completed Assembly Template. It is now ready to be used. |