Changes to Step #1
Edit by Daniel Gilbert —
Edit approved by Daniel Gilbert
- Before
- After
- Unchanged
Step Lines
[title] Prepare the Assembly Template | |
[* icon_note] You only need to do this step once. The standoffs can remain attached to the template permanently. | |
[* black] Identify the green Assembly Template PCB. It has the part number ***TD-OCSE-D-AT*** printed on it. | |
[* red] Note the orientation of the board. Standoffs will be installed on the side that says ***THIS SIDE FACES DOWN***. | |
- | [* orange] Locate three ***M2.5 × 10 mm standoffs***. |
+ | [* orange] Locate three ***M2.5 × 10 mm female standoffs***. |
[* yellow] Secure each standoff using one ***M2.5 × 6 mm pan head machine screw***, in the three locations shown. | |
[* black] Flip over the completed Assembly Template, which is now ready to be used. |