Changes to Step #1
Edit by Daniel Gilbert —
Edit approved by Daniel Gilbert
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare the Assembly Template |
|---|---|
| + | [* icon_note] You only need to do this step once. The standoffs can remain attached to the template permanently. |
| + | [* black] Identify the green Assembly Template PCB. It has the part number TD-OCSE-D-AR printed on it. |
| + | [* red] Note the orientation of the board. Standoffs will be installed on the side that says "THIS SIDE FACES DOWN." |
| + | [* orange] Locate three M2.5 × 10 mm standoffs. |
| + | [* yellow] Secure each standoff using an M2.5 × 6 mm pan head machine screw, in the three locations shown. |
| + | [* black] The Assembly Template is now ready to be used. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added