Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #1

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Prepare the Assembly Template
[* icon_note] You only need to do this step once. The standoffs can remain attached to the template permanently.
[* black] Identify the green Assembly Template PCB. It has the part number ***TD-OCSE-D-AT*** printed on it.
-[* red] Note the orientation of the board. Standoffs will be installed on the side that says ***THIS SIDE FACES DOWN***.
+[* red] Note the orientation of the board. The standoffs will be installed on the side that says ***THIS SIDE FACES DOWN***.
[* orange] Locate three ***M2.5 × 10 mm female standoffs***.
-[* yellow] Secure each standoff using one ***M2.5 × 6 mm pan head machine screw***, in the three locations shown.
-[* black] Flip over the completed Assembly Template, which is now ready to be used.
+[* green] Secure each standoff using one ***M2.5 × 6 mm pan head machine screw*** in each of the three locations shown.
+[* black] Flip over the completed Assembly Template. It is now ready to be used.

Image 2

Old Version

New Version

Image 3

Old Version

New Version