Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Stack and pin the material
[* black] Stack the mask material in the following order, from the bottom up:
[* red] One sheet of ***interface material***.
[* orange] One sheet of ***cotton fabric***, with the front side ***facing up***.
+ [* icon_note] The orientation of the fabric only matters if you're using a printed fabric that has a distinct front and back. In this stack, the front sides should be ***facing each other***. I'm using plain fabric and both sides are the same.
[* orange] The second sheet of ***cotton fabric***, with the front side ***facing down***.
- [* icon_note] The orientation of the fabric only matters if you're using a printed fabric that has a distinct front and back. In this stack, the front sides should be ***facing each other***. I'm using plain fabric with no particular orientation, so both sides are the same.
[* red] The second sheet of ***interface material***.
[* yellow] The cut ***pattern***, facing up.
[* green] ***Insert pins*** through all the layers of the stack. Make sure there are no wrinkles or bunches, and that the pattern does not extend beyond any of the edges.