Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Stack and pin the sheet material
[* black] Stack the sheetmask material in the following order, from the bottom up:
[title] Stack and pin the sheet material
[* black] Stack the sheetmask material in the following order, from the bottom up:
[* red] One sheet of '''interface material'''.
[* orange] One sheet of '''cotton fabric''', with the front side '''facing up'''.
[* orange] The second sheet of '''cotton fabric''', with the front side '''facing down'''.
[* icon_note] The orientation of the fabric only matters if you're using a printed fabric that has a distinct front and back. In this stack, the front sides should be '''facing each other'''. I'm using plain fabric with no particular orientation, so both sides are the same.
[* red] The second sheet of '''interface material'''.
[* yellow] The cut '''pattern''', facing up.
[* green] '''Insert pins''' through all the layers of the stack. Make sure there are no wrinkles or bunches, and that the pattern does not extend beyond any of the edges.