Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #18

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Reverse and flatten the mask
-[* black] Open the mask and ***turn it inside-out***. The stiffness of the interface material might make this process sort of crinkly.
+[* black] Open the mask and ***turn it inside-out***. The stiffness of the interface material might make this process a bit crinkly.
[* black] Use your fingers to ***press the front seam outwards*** until the stitching is visible and the corners are crisp.
-[* red] You can ***trim a tiny bit of extra material*** from the inside bottom corner of the mask.
- [* black] ***Cut diagonally*** to remove just the very corner of material inside the very bottom of the center seam, so the mask can sit as flat as possible against the wearer's chin.
- [* icon_caution] ***Be careful*** to not cut through any sewn seams while doing this.
[* black] ***Fold and flatten the mask*** in half, with the outside surface facing out.
[* black] The mask is finished. ***Nice job!***

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version