Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #16

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Fold and sew the front seam
[* black] ***Fold the mask in half***, aligning the two bottom corners with each other.
[* icon_caution] ***The mask should be inside-out***, so that the inside of the mask is facing out and the side with the straps attached is facing in.
[* icon_note] You can pin the mask together if you want, but it was stiff enough that I didn't need to.
[* red] Carefully ***sew the center seam***, running from the bottom corner to the upper straight line.
- [* icon_note] ***Stop and adjust your angle*** at the half way point to follow the mask's contour.
- [* icon_note] Sew roughly ***1/4" from the edge***.
-[* orange] End at the point where the upper straight line meets the edge of the mask. See the ***orange arrow*** in the photo for reference.
+ [* icon_note] ***Stop and adjust your angle*** at the halfway point to follow the mask's contour.
+ [* icon_note] Sew roughly ***1/4" (6 mm) from the edge***.
+[* orange] Stop at the point where the upper straight line meets the edge of the mask. See the ***orange arrow*** in the photo for reference.