Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Transfer the straight lines
[* black] '''Place the mask on top of the pattern''' again, aligning the bottom edges.
[* red] '''Mark a point on the mask''' that's about 1/4" (6 mm) above the center of the acute angle cutout point.
[* red] '''Mark a point on the mask''' that's about 1/4" (6 mm) above the center of the acute angle cutout point.
[* orange] '''Draw straight lines''' connecting that point to the two marks along the curve that you made earlier.
[* yellow] '''Make two new marks''' along the curve where the other dashed lines on the pattern intersect with the mask.
[* green] '''Draw two more straight lines''' connecting these two points to points about 1/8" (3 mm) above the obtuse angle points along the bottom edge of the mask, as pictured.
[* green] '''Draw two more straight lines''' connecting these two points to points about 1/8" (3 mm) above the obtuse angle points along the bottom edge of the mask, as pictured.