Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

+[title] Place and pin the insert
+[* red] Place the prepared nose bridge insert inside the mask, ***between the two layers of interface material***.
+ [* icon_note] Push the insert ***all the way into the seam***, so it's as close to the top edge of the mask as possible.
+ [* icon_note] Use the two marks you made in the previous step to ***align the insert and center it***.
+ [* icon_caution] The insert should be ***slightly shorter*** than the distance between the two marks, and it ***should not extend beyond either mark***.
+[* orange] Use a few pins to the ***hold the insert in place*** against the seam.

Image 1

No previous image

Added