Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by Daniel Gilbert

Edit approved by Daniel Gilbert

Before
After
Unchanged

Step Lines

[title] Place and pin the insert
[* red] Place the prepared nose bridge insert inside the mask, '''between the two layers of interface material'''.
[* icon_note] Push the insert '''all the way into the seam''', so it's as close to the top edge of the mask as possible.
[* icon_note] Use the two marks you made in the previous step to '''align the insert and center it'''.
[* icon_caution] The insert should be '''slightly shorter''' than the distance between the two marksstrap attachment points, and it '''should not extend beyond either markpoint'''.
[* icon_caution] The insert should be '''slightly shorter''' than the distance between the two marksstrap attachment points, and it '''should not extend beyond either markpoint'''.
[* orange] Use several pins to the '''hold the insert in place''' against the seam.

Image 1

Old Version

New Version