Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Make sure that you have both of the necessary new parts, and that they are undamaged:
    • Make sure that you have both of the necessary new parts, and that they are undamaged:

    • White plastic Jumper Board Spacer.

    • Jumper Board marked with part number TD-TDMY-A and assembled with three 1x3 male pin headers.

    • The Jumper Board pictured here is green, but yours may be a different color.

    • Check to make sure that none of the Jumper Board pins are bent. If any of them are slightly bent, attempt to bend them back into position with a small pair of pliers. If any of them are damaged, please contact us for a replacement.

  2. Place the TinyNES on a flat work surface. Make sure that no cables, controllers, or cartridges are connected to it. Remove the 8 marked M2.5 x 10 mm flat head machine screws. Put the screws aside, being careful not to lose them.
    • Place the TinyNES on a flat work surface. Make sure that no cables, controllers, or cartridges are connected to it.

    • Remove the 8 marked M2.5 x 10 mm flat head machine screws.

    • Put the screws aside, being careful not to lose them.

    • Lift the top panel off of the enclosure and put it aside.

    • If the white plastic cartridge guide comes off with the top panel, remove it from the top panel and reposition it around the cartridge connector.

Daniel Gilbert

Member since: 12/07/2019

2,103 Reputation

9 Guides authored