You're viewing a previously published revision of this guide. View latest revision

Oct 01, 2021 - 10:10:57

Oct 02, 2021 - 12:10:12 Oct 02, 2021 - 12:10:57 Oct 02, 2021 - 12:10:41 Oct 02, 2021 - 12:10:20 Oct 02, 2021 - 12:10:50 Oct 02, 2021 - 12:10:01 Oct 02, 2021 - 12:10:17 Oct 02, 2021 - 12:10:32 Oct 02, 2021 - 12:10:13 Oct 02, 2021 - 12:10:54 Oct 02, 2021 - 12:10:18 Oct 02, 2021 - 12:10:24 Oct 02, 2021 - 12:10:18 Oct 02, 2021 - 12:10:04 Oct 02, 2021 - 12:10:23 Oct 02, 2021 - 12:10:58 Oct 02, 2021 - 12:10:51 Oct 01, 2021 - 11:10:58 Oct 01, 2021 - 11:10:52 Oct 01, 2021 - 11:10:53 Oct 01, 2021 - 11:10:17 Oct 01, 2021 - 11:10:17 Oct 01, 2021 - 11:10:08 Oct 01, 2021 - 11:10:26 Oct 01, 2021 - 11:10:16 Oct 01, 2021 - 11:10:22 Oct 01, 2021 - 11:10:35 Oct 01, 2021 - 11:10:23 Oct 01, 2021 - 11:10:15 Oct 01, 2021 - 10:10:57 Oct 01, 2021 - 10:10:31 Oct 01, 2021 - 10:10:15 Oct 01, 2021 - 10:10:30

Newer

µClouds SE Assembly Template Instructions

Written By: Daniel Gilbert

Comments: 0
Favorites: 0

µClouds SE Assembly Template Instructions

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Step 1 Prepare the Assembly Template

This step only needs to be done once. The standoffs can remain attached to the template permanently for subsequent iterations.

Identify the green Assembly Template. It has the part number TD-UCSE-D-AT printed on it.

Note the orientation of the board. The standoffs will be installed on the side that has THIS SIDE FACES DOWN printed on it.

This step only needs to be done once. The standoffs can remain attached to the template permanently for subsequent iterations.
Identify the green Assembly Template. It has the part number TD-UCSE-D-AT printed on it.
Note the orientation of the board. The standoffs will be installed on the side that has THIS SIDE FACES DOWN printed on it.
Locate two M2.5 × 10 mm female standoffs.
Secure each standoff using one M2.5 × 6 mm pan head machine screw in each of the two locations shown.
Flip over the completed Assembly Template. It is now ready to be used.